Dish decoder installation

Multi TV signals will reach your decoder from a satellite called Astra 2B. Its location is on the coordinates But understand that Multi TV is not the only broadcaster using the same satellite. That means you can add several new parameters to your satellite receiver to identify other signals and add more Multi TV channels. Alternatively, consider re-scanning your MultiTVworld digital box to get more channels without new frequencies:.

Your Digibox will start the re-scan automatically. Multi TV follows the same principle of available satellite TV installation. But all you have to do to get things right is input the satellite tracking parameters and then skew or track to pick up the Multi TV signals. The Multi TV frequency is When installing your satellite dish, ensure it faces east to get more signals. We provide a free collection and delivery service when we repair your television. Leave the hard work to us.

Then consider safety. We have public liability insurance to cover us while working at your home and goods in transit insurance while we transport your expensive LCD, Plasma or LED Television. If you are using an AV mini jack cable, plug the single jack into the back of your decoder. Match the colours of the connectors to the colour of the ports red to red, white to white and yellow to yellow. Once your decoder has been installed, completed scanning and channel is playing, you will need to activate it.

Please follow these steps:. Breaking News Openview no signal. Today on Openview channel OpenView — Clearing on-screen error messages. OpenView is compatible with any satellite dish. Setup guide How to connect If you already have a satellite dish and would like to install and activate your decoder, please follow the following steps: To connect your decoder to the satellite dish, you will need to connect the LNB cable from your satellite dish to the LNB IN or DISH IN slot at the back of your decoder.

There are three ways to connect your decoder to your TV: RCA Cable If you are using an RCA cable connect the cables to the back of your decoder — matching the colours of the connectors to the colours of the ports red to red, white to white and yellow to yellow.

To power your decoder, you will need to connect the power cable to the decoder and connect it to a power source. Your decoder should then switch on and start scanning.

Once scanning is complete you will see channel Your decoder is now ready to be activated. How to activate Once your decoder has been installed, completed scanning and channel is playing, you will need to activate it.

Write down your STB number. Dial the number on the bottom right-hand corner using a cellphone and follow the prompts. Use your STB number to complete your decoder activation. Your decoder may reboot and update its software during the activation. Please allow a few minutes for this.

Once your decoder has been activated, you can use buttons on your remote control to change channels. Please do not attempt to activate your decoder if you have already attempted to activate it before.